Product Overview and Specifications

This is a valuable product that has already been discontinued.

Number of pixels: 512 (H) x 480 (V)
Camera input: 2 points Power supply voltage: DC24V ±10%

Please see the manufacturer page for details.

Product Condition

I confirmed that it works properly. We are checking the following.
・Connect a camera (CV-020) to each of the "CAMERA-1" and "CAMERA-2" ports, and the captured image will be displayed correctly on the monitor.
・Be able to connect this device and a computer via Ethernet and operate according to commands sent using terminal emulator software.
- Connect this device and the computer via RS-232C, and use the computer's serial communication software and the functions on the device's "IO monitor" and "RS-232C input/output" screens to successfully send and receive data.
- Input signals to all input terminals of the parallel I/O connector and terminal block, and ensure that each signal is correctly recognized by the controller.
- Connect a load (buzzer) to all output terminals of the parallel I/O connector and terminal block, and ensure that each output circuit operates normally.
- Insert a memory card, read and write settings, and ensure that the memory slot operates normally.

Console (OP-42342) is not included.

One of the tabs on the parallel I/O connector is missing, but the connector can be installed. It does not fall out easily, but it is a little difficult to remove because the connector does not come up even if you move the tab when removing it.
There are other scratches, but nothing noticeable.